 重山光電ZSEM |
參考報價：電議 型號：
產地： 在線咨詢
|
1.產品名稱：超寬鋰帶Lithium ultra wide belt
外觀：銀白色金屬
熔點：180.5℃
密度：0.534g/cm3
2.規格及給公差 Specification and tolerances
單位：mm | 規格 | 厚度及寬度公差 | ||
牌號 | 厚度 | 寬度 | 厚度公差 | 寬度公差 |
Li-1 | 0.2～1.0 | 80～120 | ±0.01 | ±0.1 |
Li-2 | 1.0～2.0 | ±0.02 | ±0.2 | |
3.化學成分 Chemical analysis
單位:% | 雜質含量（max) | |||||||||||
牌號 | Li(min) | K | Na | Ca | Fe | Si | Al | Ni | Cu | Mg | Cl | N |
Li-1 | 99.9 | 0.001 | 0.02 | 0.02 | 0.001 | 0.01 | 0.005 | 0.001 | 0.001 | 0.001 | 0.002 | 0.01 |
Li-2 | 99.95 | 0.001 | 0.01 | 0.01 | 0.001 | 0.003 | 0.003 | 0.001 | 0.001 | 0.001 | 0.002 | 0.01 |
Li-3 | 99.99 | 0.0005 | 0.001 | 0.0005 | 0.0005 | 0.0005 | 0.0005 | 0.0005 | 0.0005 | 0.0005 | 0.0005 | 0.003 |
注：鋰含量為100%減去表列雜質含量之差，如有特殊要求，雙方協商。
4.表面質量 The surface quality
鋰帶表面應平直,光亮，不應有油斑或其他雜物，不得有目視可見的氧化物及氮化物，不應有皺邊、孔眼、裂縫、折痕、壓線等缺陷，允許有輕微的加工條紋和輥印。鋰帶的邊緣應整齊，無裂口。鋰帶不得有分層和夾雜
Lithium surface should be flat, light, there should be no oil stain or other sundry, must not have visual visible oxide and nitride, should not have ruffled, perforation, defects such as cracks, creases and line pressing, allow a slight processing stripe and roller printing. The edges of the lithium belt should be neat and free of cracks. The lithium belt should not be stratified and mixed.
5.包裝 packaging
鋰帶卷繞在卷取盤上，在干燥環境中充氬氣密封包裝于鋁塑復合袋中。
The lithium coil is wound on the reel and sealed in a dry environment with argon sealed in the aluminum plastic compound bag.
6.處理/儲存Processing/storage
鋰帶的處理應在惰性氣體或在干燥空氣中進行，鋰帶的保存期為六個月。
The treatment of the lithium belt should be carried out in an inert gas or in dry air, with a shelf life of six months.
